Opsview Monitor allows the use of a couple of parameters in the URL to access some pages directly. These are as follows:

## autoSelectHost

Example: `http://opsview/monitoring/#!?autoSelectHost=Opsview`

This parameter will open the monitoring navigator page with the named Host selected, so all of the service states are shown within the checker at the bottom of the page

## autoSelectService

Example: `http://opsview/monitoring/#!?autoSelectHost=Opsview&autoSelectService=Disk: /`

Note: This must be used in conjunction with `autoSelectHost`

This parameter will open the `Info` tab in the `Investigate` modal for the named Service Check on the Host.